This Full House DIY Tuning upgrade kit is perfect if you already have a J3 Chip but want to start DIY tuning your own Falcon!
The included J3 Programmer gives you the ability to do your own tuning, but this Full House DIY Tuning upgrade kit also includes a TechEdge 2J WBo2 controller, and Bosch LSU 4.9 WBo2 Sensor to monitor your AFRs and datalog other engine vitals. Using this kit and your existing J3 Chip you gain full control of fuel, spark, idle, limiters and many other parameters within the ECU, and you can monitor and log Air Fuel Ratio, TPS, Intake temps, Vehicle Speed, RPM and more!
This kit includes:
- Genuine Bosch LSU 4.9 Wideband O2 sensor
- TechEdge 2J9 Wideband O2 Controller
- 1.7m wideband sensor cable
- RJ45-DB9 RS232 Serial cable
- Power cable
- J3 Programmer (inc Mini USB Cable)
Use the drop down if you would like us to create you a Custom Tune as a base to get you started. See Stage 1 / 2 Custom Tune and Stage 3 Custom Tune for more information about which tune type is required for your setup.
If your laptop does not have a 9-pin Serial port, you will need to add a USB Serial Cable. You should also consider a TechEdge LD02 Wideband LED Display or TechEdge LA1 Round Wideband Gauge Display to view your AFRs in the vehicle without needing a laptop.
V8 Falcons can log the MAF directly, but due to the type of MAP sensor in EA-EL 6 Cylinder Falcons, you will need a GM 2 Bar MAP Sensor to log MAP.
Note: Using this kit will require some knowledge of tuning – we recommend new starters have a good read of the tuning resources in our Library before purchasing.